smartctl 5.43 2012-06-30 r3573 [i686-w64-mingw32-win7(64)] (sf-5.43-1) Copyright (C) 2002-12 by Bruce Allen, http://smartmontools.sourceforge.net === START OF INFORMATION SECTION === Model Family: Seagate Momentus 5400.6 Device Model: ST9500325AS Serial Number: S2W0JM01 LU WWN Device Id: 5 000c50 03e0581b7 Firmware Version: 0003SDM1 User Capacity: 500 107 862 016 bytes [500 GB] Sector Size: 512 bytes logical/physical Device is: In smartctl database [for details use: -P show] ATA Version is: 8 ATA Standard is: ATA-8-ACS revision 4 Local Time is: Sun Jan 10 14:44:48 2016 SMART support is: Available - device has SMART capability. SMART support is: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED Warning: This result is based on an Attribute check. General SMART Values: Offline data collection status: (0x00) Offline data collection activity was never started. Auto Offline Data Collection: Disabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 0) seconds. Offline data collection capabilities: (0x73) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. No Offline surface scan supported. Self-test supported. Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 1) minutes. Extended self-test routine recommended polling time: ( 140) minutes. Conveyance self-test routine recommended polling time: ( 2) minutes. SCT capabilities: (0x103b) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 10 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE 1 Raw_Read_Error_Rate 0x000f 116 099 006 Pre-fail Always - 104486460 3 Spin_Up_Time 0x0003 099 098 000 Pre-fail Always - 0 4 Start_Stop_Count 0x0032 097 097 020 Old_age Always - 3677 5 Reallocated_Sector_Ct 0x0033 100 100 036 Pre-fail Always - 0 7 Seek_Error_Rate 0x000f 082 060 030 Pre-fail Always - 196410764 9 Power_On_Hours 0x0032 091 091 000 Old_age Always - 8023 10 Spin_Retry_Count 0x0013 100 100 097 Pre-fail Always - 0 12 Power_Cycle_Count 0x0032 097 097 020 Old_age Always - 3671 184 End-to-End_Error 0x0032 100 100 099 Old_age Always - 0 187 Reported_Uncorrect 0x0032 092 092 000 Old_age Always - 8 188 Command_Timeout 0x0032 100 099 000 Old_age Always - 12885098515 189 High_Fly_Writes 0x003a 100 100 000 Old_age Always - 0 190 Airflow_Temperature_Cel 0x0022 065 056 045 Old_age Always - 35 (Min/Max 28/37) 191 G-Sense_Error_Rate 0x0032 100 100 000 Old_age Always - 746 192 Power-Off_Retract_Count 0x0032 100 100 000 Old_age Always - 445 193 Load_Cycle_Count 0x0032 037 037 000 Old_age Always - 127701 194 Temperature_Celsius 0x0022 035 044 000 Old_age Always - 35 (0 9 0 0 0) 195 Hardware_ECC_Recovered 0x001a 053 046 000 Old_age Always - 104486460 197 Current_Pending_Sector 0x0012 100 100 000 Old_age Always - 1 198 Offline_Uncorrectable 0x0010 100 100 000 Old_age Offline - 1 199 UDMA_CRC_Error_Count 0x003e 200 200 000 Old_age Always - 1 254 Free_Fall_Sensor 0x0032 100 100 000 Old_age Always - 0 SMART Error Log Version: 1 ATA Error Count: 8 (device log contains only the most recent five errors) CR = Command Register [HEX] FR = Features Register [HEX] SC = Sector Count Register [HEX] SN = Sector Number Register [HEX] CL = Cylinder Low Register [HEX] CH = Cylinder High Register [HEX] DH = Device/Head Register [HEX] DC = Device Command Register [HEX] ER = Error register [HEX] ST = Status register [HEX] Powered_Up_Time is measured from power on, and printed as DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes, SS=sec, and sss=millisec. It "wraps" after 49.710 days. Error 8 occurred at disk power-on lifetime: 8021 hours (334 days + 5 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 51 00 fc 06 32 02 Error: WP at LBA = 0x023206fc = 36833020 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 61 00 08 38 f4 e2 40 00 00:11:35.064 WRITE FPDMA QUEUED 61 00 08 a0 ac 44 41 00 00:11:35.063 WRITE FPDMA QUEUED 61 00 08 e0 a2 3e 41 00 00:11:35.062 WRITE FPDMA QUEUED 61 00 08 70 da 3f 41 00 00:11:35.061 WRITE FPDMA QUEUED 60 00 00 e0 07 32 42 00 00:11:35.061 READ FPDMA QUEUED Error 7 occurred at disk power-on lifetime: 8021 hours (334 days + 5 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 51 00 fc 06 32 02 Error: WP at LBA = 0x023206fc = 36833020 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 61 00 00 e0 2b 1d 41 00 00:13:32.584 WRITE FPDMA QUEUED 61 00 00 e0 2a 1d 41 00 00:13:32.583 WRITE FPDMA QUEUED 61 00 00 e0 29 1d 41 00 00:13:32.583 WRITE FPDMA QUEUED 61 00 00 e0 28 1d 41 00 00:13:32.582 WRITE FPDMA QUEUED 61 00 00 e0 27 1d 41 00 00:13:32.582 WRITE FPDMA QUEUED Error 6 occurred at disk power-on lifetime: 8021 hours (334 days + 5 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 51 00 fc 06 32 02 Error: WP at LBA = 0x023206fc = 36833020 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 61 00 00 60 0f 05 49 00 00:17:26.212 WRITE FPDMA QUEUED 61 00 00 60 0e 05 49 00 00:17:26.211 WRITE FPDMA QUEUED 61 00 00 e0 29 1d 41 00 00:17:26.168 WRITE FPDMA QUEUED 61 00 00 e0 28 1d 41 00 00:17:26.167 WRITE FPDMA QUEUED 61 00 00 e0 27 1d 41 00 00:17:26.167 WRITE FPDMA QUEUED Error 5 occurred at disk power-on lifetime: 8021 hours (334 days + 5 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 51 00 fc 06 32 02 Error: WP at LBA = 0x023206fc = 36833020 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 61 00 00 c0 ca 01 49 00 00:12:24.359 WRITE FPDMA QUEUED 61 00 00 c0 c9 01 49 00 00:12:24.358 WRITE FPDMA QUEUED 61 00 00 e0 28 1d 41 00 00:12:24.349 WRITE FPDMA QUEUED 61 00 00 e0 27 1d 41 00 00:12:24.349 WRITE FPDMA QUEUED 61 00 40 d8 1d 31 42 00 00:12:24.348 WRITE FPDMA QUEUED Error 4 occurred at disk power-on lifetime: 8020 hours (334 days + 4 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 51 00 fc 06 32 02 Error: WP at LBA = 0x023206fc = 36833020 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 61 00 00 c0 c2 ff 48 00 00:11:15.686 WRITE FPDMA QUEUED 61 00 00 b8 09 21 41 00 00:11:15.656 WRITE FPDMA QUEUED 61 00 00 b8 08 21 41 00 00:11:15.655 WRITE FPDMA QUEUED 61 00 00 b8 07 21 41 00 00:11:15.655 WRITE FPDMA QUEUED 61 00 20 60 bd b0 4c 00 00:11:15.654 WRITE FPDMA QUEUED SMART Self-test log structure revision number 1 No self-tests have been logged. [To run self-tests, use: smartctl -t] SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay.